Wireless PA

Instructions for the Wireless PA system.

IMPORTANT!

If you connect to this speaker using Bluetooth, you MUST remove the device from your computer when you are finished. Not just 'disconnect', but remove or 'forget' the device, otherwise the next user may have problems. (see below)

To use the wireless PA system, turn on the power on both the speaker and the wireless microphone receiver.

The power switch for the speaker is on the back of the unit, above the power cord.

The power switch for the receiver is on the front, on the right side. To turn on the receiver, briefly hold down the power button.

Once the speaker and the receiver are powered on, turn on the wireless microphone. The power switch is on the top. Remember to turn it off when you are done, or the next person will find that the battery is dead.

The wireless microphone will work with other microphone elements. The element may not plug in easily, but it does fit the unit, so you may need to press it in to connect it.

To use the element that is with the unit, clip it to your shirt or to the outside of your mask.

If you are too close to the speaker, you may get feedback. Adjust the microphone volume on the front of the receiver to get the best level. There is also another volume control on the back of the speaker, but avoid adjusting that. If you are not getting any sound you may want to check the second volume control on the back.

Using Bluetooth

IMPORTANT!

If you connect to this speaker using Bluetooth, you MUST remove the device from your computer when you are finished. Not just 'disconnect', but remove or 'forget' the device, otherwise the next user may have problems.